The FlowMeter PRO Revision 3.6 is a flow measuring turbine that can be attached directly to your mother board! It will measure the flow of in your watercooling system and indicate the flow value in revolutions per minute so that it can be read directly by your motherboard's BIOS.
The integrated blue LED also allows a visual indication of the flow as it flashes with the turbine revolutions - plus it is a cool optical effect! Designed for an extreme life span and quite operation, this flow meter will probably outlive your system! Designed for 8mm I.D. / 10mm O.D. Tubing.

By connecting the FlowMeter PRO directly to your motherboard, you can check your system's flow rate via BIOS monitoring software. The BIOS reads the signal as if it was a tachosingal from a standard CPU fan. The linear signal indicates the flow of liters per minute. 2800 pulses equals 1 liter per minute, so 0.7 liters (ideal flow for an innovatek system) would be seen in the BIOS as 1960 RPM.

Comes with:
- FlowMeter PRO Rev. 3.6
- LED with 3-pin Fan header connector
- Compression fittings for 8mm ID / 10mm OD tubing

Warning: Use of fluids other than the Innovatek Protect family is not recommended. Innovatek will not RMA defective products that have used alternative fluids, including UV Dyes. Do not use alcohol based cleaners on innovatek products.

Did you know?
The innovatek Protect Products are the only licensed corrosion protection fluids in the PC-field that are officially approved by EHEIM for their pumps. Why take risks? Be save and trust the specialists!

Note: Flow Meter comes native with compression fittings for 8mm ID / 10mm OD tubing ~(1/4"ID / 3/8"OD). Other G1/4 threaded fittings can be used with the adapters listed in the options below.

• Connects directly to your computer's motherboard
• Pulse rate is 2800 pulses per liter
• Specially designed measuring chamber
• Uses 3-pin fan connector
• 55 cm cable
• Compact design: 79 (L) x 41 (W) x 21 (H) mm (Including fittings)
• Designed for 8mm ID / 10mm OD tubing
• Compression Fittings (Non-exchangeable)
• Blue LED flashes for each revolution - will appear constant during normal flow

04-17-2011
Reviewer: J.Vaughan (15)
I havent installed the item due to its small intake and outake holes. I''m worried it might actually restrict flow and put more strain on the pump. Definately not worth $50, be weary if you have tubing 3/8" ID or larger.

06-05-2007
Reviewer: Michael (1)
Works well, unless your system uses .500" tube. (I was able to slip the 1/2" tube over the barbs without using the normal securing nuts and then use a wire tie to temporarily secure the meter in place...) I''m looking to replace the fitting but it may not be feasible being that they do not appear to be a standard fitting. It did tell me that my pump that is supposed to flow 1 liter is only flowing about 1/3 which is what I suspected and why I purchased this to confirm that due to rising temps and cavitation in my Asetek 12v Extreme pump.