High-precision thermal sensor for G1/4 inch thread. Can directly be installed into a thread of a reservoir such as Coolplex, Aluminum tube or Bullseye are screwed and seal of a durable O-ring. The shaft is knurled, which facilitates the insertion by hand, the remaining wall thickness is reduced to <1mm, which enables precise and fast measurements. It is universally applicable to the devices sold here at FrozenCPU.com.

Material:	Black Nickel plated brass
Accuracy:	0.3 C (precision measurement possible)
Cable:	2-pin connector with 50cm cable
Resistance 10KOhm:
Upper diameter:	18mm
Top Length:	8mm
Overall length:	30mm
Thread length:	10mm
Lower sensors Length:	12mm
Sensor diameter:	below 6mm, 7mm 2nd Stage

05-23-2011
Reviewer: Austin (4)
The sensor works fine. But while I was moving some parts inside my case, the wire connecting the sensor to my temp display came off. It took little to no effort. I was able to reconnect the wire, but had to hold it together with electrical tape. I wouldn''t buy this again. Save yourself the inconvenience and get a different brand temp sensor.