The RP-1000 is the standalone reservoir and pump unit used in PC4-1000 1kW series systems. It features a powerful >6 L/min (1.8 GPM), >3m (10ft) head pump. The RP-1000 integrates the control board, LED display, reservoir, and pump into a single 5.25" (CD) bay. It doesn't includes fittings. The fittings are available in the options below to best match your system.

Due to the performance of the pump, it is more audible when compared with Koolance dual-pump (PC2/PC3, 1-2L/min) systems. The degree of this can depend upon your particular chassis.

IMPORTANT NOTE: Unlike Koolance dual-pump units, such as those of PC2/PC3 generations, the RP-1000 can not be run dry. Never test this product without coolant. Should this occur, the product would no longer be covered under Koolance's product warranty.

Comes with:
- 5.25" bay reservoir & pump (LED display, control board)
- 3 x temperature sensors
- ATX pass-through wire
- Bay mounting screws
- Manual

Picture shown with Koolance 3/8" (10mm) ID G1/4 Threaded Nozzles Pair (NZL-V10KG), these are not included!

Model:	RP-1000BK
Materials:	Aluminum, Acrylic
Tubing Size, ID:	3/8" (10mm) or 1/4" (6mm)
Size (W x H x D):	5.8" x 1.65" x 8.74" (14.8cm x 4.2cm x 22.2cm)
Weight:	2 pounds (907g)

12-19-2007
Reviewer: Anonymous
I was looking for a pump that would take up little room and emilinate clutter in my case, and even though my case is a full tower, I just wanted a good looking build. I went with this, an Innovatek G-Flow cpu block, and a danger den fillport reservoir. Together with this unit I''ve had great OCing sucess, a e6600 to 3.7 ghz, running 3 degrees above ambient temp. at full load. This is a good pump, not intensly strong, but enough to cool my system very well, and puch through a triple 120 mm res, the cpu, and 2 video cards, and a crap load of 3/4 in tubing. I highly reccomend it, although it is on the expensive side. It looks great, in and out, once installed, and programming was simple.