The 250mm Silent Case Fan is just asking to be installed on a case side panel. With its massive area, this fan can cool an entire motherboard. The fan kicks out 105 CFM while making only 19 dBA - less noise than most 80mm fans!

The included black bezel and grill will cover the hole in the side panel - you can cut it with a pair of Tin Snips and it will still look professional once it is installed.

• 250mm DC Cooling Fan (Including bezel) for PC Case
• 13 Bladed Clear Fan with optimal blade pitch for CFM
• Mesh Metal Fan Grill/Filter
• Black External Trim Ring
• Quiet Operation
• Do It Yourself (DIY)

Color:	Clear Fan with Black bezel
Fan Dimension:	250 x 250 x 30 mm
Rated Voltage:	DC 12V
Wattage:	11 Watts
Amperage:	0.9A
Fan Speed:	820RPM ±5%
Airflow:	105.2 CFM ±5%
Noise:	19 dBA
Connector:	4 Pin pass-through power connector

06-21-2009
Reviewer: Atmosck (1)
This makes a great modification for a tight case. There''s not a lot of breathing room in my Antec p180, so i was having some trouble with high vga temps (GeForce GTX 260). It dropped my video card''s temperature a whole 10 degress C, from 82 under load and 60-ish idle to 72 under load and 50-ish idle. It also dropped the cpu temps about 3-4 degrees. I wish i had the foresight to get a wider case or a smaller CPU cooler though, because with a 120MM cooler i have almost no clearance from the side of the case, so i have to have the fan protruding from the case. The grill wasn''t built to the exact same measurments as the fan, so there''s some lateral pressure on the screwholes to get it to fit with the fan. It also could have come with screws and a template, but it''s no biggie. I also wish FrozenCPU offered an air duct meant for this fan so it could take air from the front and having something up against the side of the computer wouldn''t be such a hindrance.

12-14-2008
Reviewer: Chibo (1)
I bought two of these one for my sons computer and mine. As for the installation it was fairly easy because I had the tools to install it. But the one I put in my computer half-assed died and I''ve been having to jump start it by pushing it to go. So I''m ordering another one only because its extremely quiet and pushes enough air to keep my computer cool. So I rate it a 4 because I''m having to replace mine, could be a defective fan but for 23 bucks I can''t complain and it still kinda works.

07-23-2008
Reviewer: Skyhawk (1)
Pros: Large fan, very quiet. Cons: No screws. No template for cutting (not really a big deal to me). Arrived with plastic screw post broken! Comments: I wish it pushed a little more air. Its a decent fan, but I''m rating it a 3 because of the cons.

06-16-2008
Reviewer: nice fan (1)
I put this fan into a radiator shroud to attach to a 4x120 radiator I have at the upper rear of my mozart TX case, pulling the air from the rad and it keeps 2x8800GTX that have been OCd pretty heavily (645core, 1900shader, 2200mhz memory) and my temps barely reach 50c even after several hours of gaming. before, when I had 4x120mm fans that pushed 65cfm my temps would hit almost 70c with the same setup !

03-09-2008
Reviewer: E. Anderson (2)
This fan is practically silent. Not only that, it also moves a lot of air. Unfortunately, the included mounting hardware doesn''t work as well. When I mounted the fan to the ring to test it, all four screw posts cracked. Also, the included mesh cover has a visible gap at the edge. There is no cutting pattern included with this fan, so you''ll have to do the measurement yourself. I still rate this a 4 because the fan is good.