The Thermaltake Flow TX Liquid Cooling Flow Meter attaches to either 1/4" or 3/8" ID tubing systems and provides an attractive visible display of your system's flow rate.

Easy to install:
The flow meter can be placed anywhere within the liquid cycle to indicate the movement of the coolant.

Quick install connectors:
The connection of the flow meter is suitable for tubing of ID 1/4” (6.4mm) and 3/8" (9.5mm).

The device can be installed easily, saving your time

Quality:
Provides reliable flow monitoring.

Easy to observe:
Transparent cover clearly shows the movement of the coolant.

P/N:	CL-W0080
Dimensions:	60 x 35 x 25 mm (H x W x D)
Weight:	142 g
Number of Impeller Blades:	Five
Quick Install Connectors:	For 1/4“ ID (6.4mm) tubing For 3/8“ ID (9.5mm) tubing

09-01-2008
Reviewer: Anonymous
Keep it this short, its junk, if you over tight it, it will leak because this does not use barbs, like most others, this can ALSO CRACK!, and last, while it Spins when liquid is flowing there WILL be at times that it WILL STOP! spining] you would have to tap it to make it move again....save your money & time, i LOST BOTH, oh well..........

12-26-2007
Reviewer: Ragin Cajun (1)
Cheap, Functional. My hoses were too big for the fittings so I had to use clamps, otherwise, Spins when liquid is flowing.

11-12-2007
Reviewer: surfpangea (1)
I orderd three of these items they arrived with four fittings thermaltake no 7 and 9 hose sizes threads on 7 did not match at all slipped all the way in 9 threads slid all the way but two turns had to retap with larger thread pattern and use adapter would not suggest this item. sorry thermaltake you dropped the ball on this one

09-21-2007
Reviewer: MAGMAN (1)
After 2 weeks of use I noticed a leak from the fitting (a steady drip). After tightening it started to shoot out a tiny stream. I tried reaplying more teflon tape as well but it still leaked. Needless to say I ended up busting out the good old JB Weld, so now it looks ugly but it doesn''t leak. After all that fuss I found out later that the darn thing is a real pain in the butt about catching air bubbles and holding them in the prop. area. Every now and then I have to shake the crap out of it just to remove the air bubbles. My advice... There are plenty of other flow meters out there that surely perform better than this one; So don''t waste your time or money... you don''t need another headache when setting up your liquid cooling.