|Phone: 1.877.2.GET.COOL (1.877.243.8266) Hours: M-F 10-6, Sat 11-4||45964 fans like us!|
113 users browsing
My Wish List
Who We Recommend
We all put so much into our computers why not show it off with a custom DIY acrylic window! Low profile molding keeps it clean and sleek. At 1/8" thick these acrylic windows are solid construction not like manufacturer windows that are flimsy!
Laser Cut cast acrylic window kit 18.01 Tall x 15.35 wide x 1/8 thick. All of our windows come with instructions on how to install as well as some low profile molding to finish it off.
Total Reviews: 1 Average Rating:
Reviewer: Steve (1)
I would to just say this is a huge window. Laser cut very nice! But be prepared to spent at least 4 hours installing this bugger!! I had no problem cutting the opening in my side panel, but installing the window into the rubber took about 30 minutes and beware take your time if you rush it you going to end up with a broken window! Inserting the window wasn''t really that bad but putting the locking rubber in was a pain in my ASS !!!! Turned out to be a great looking window so I could add 2 more 120mm intake fans so I can get positive air pressure in my Nzxt Switch 810 case. I was able to take the blank right hand side panel and switch it to the left side where I installed the new window. Now I have the original windowed side panel on the opposite side so everyone can see my nice and neat wire management . I would recommend this to friends to buy.