This little device is a Pulse Width Modulation 6x fan controller that is capable of controling a number of fans! With three rheo dials supporting two fans each and two on/off switches (great for turning cathodes on and off!), this unit is ideal for any computer user with lighting and low noise in mind.

Included:
-Fan controller unit
-bay mounting screw (4 pcs)
-3-pin fan extension cable (2 pcs)
-4-pin power supply extension Y cable (1 pcs)
-4-pin female/female power supply cable for 12V DC output switch

• Control up to 6 fans
• Tree rheostat dials
• Two On/Off Switch

Specifications:	Pulse width modulation fan speed control module
Voltage:	12V DC Input 12V DC output x2 (3A/12V DC)
Wattage:	20W per fan speed control channel
Supports:	Control 6 fans (2 fans per channel)

08-13-2008
Reviewer: jaycam (2)
Like the other reviews say, it does what it''s supposed to do. Dimming/Brightening of the LED lights is not as drastic as I would like but I''m okay with that. Unlike other reviews I didn''t have any problems with it fitting in my case; Lian Li PC-7BW Plus II. Also, LEDs for the 12v seem backwards to me...green should be on and red should be off. Definitely a recommended buy!

02-05-2008
Reviewer: great (1)
does what it should, blue LED''s look awesome, and they shine into my res below giving the liquid an erie glow. really tight fit, had to sand sides to get it to work

01-27-2008
Reviewer: wolff956 (1)
it does what it says, gives me better control of my case fans than the biult in mother board software. did not fit the plastic front cover on my kingwin case, I found it easier to remove some of the offending plastic than to make a new face plate for the controler.

03-26-2007
Reviewer: Joe V (3)
Has good features, i love the two 12v switches, however only comes with two 3pin extension cables, more would have been nice. Tight fit.

01-17-2007
Reviewer: lennox (1)
Good controller, I like the simple layout and direct fan connectors. Only beef with this product is that it was too large to fit into the slot on my P180 case, so I had to make my own face plate for it. (Real pain to do but it looks nice :))