 |
06-12-2009
 screwed in a good way
These screws and grommet combo''s are the perfect fit for those who have purchased a normal tower and wanted to get rid of excess vibration from hard-drives! When they arrived I noticed that they are too large for standard case holes that are pre-punched for hard-drive screws. In order to remedy this you will need a 15/64ths (.234”) drill bit and a steady hand. After enlarging the holes for the grommet, (remove your hard drives first!), I test-fit the hard-drive with the grommets in. They slid in with minimal resistance and the screws held the drives in securely! After reassembly and booting, I thought I forgot to plug the hard-drives in. The vibration is GONE from my tower.
Thanks FrozenCPU!
Note: When installing the screws you only need to tighten them until they are firm, over tightening will result in cutting the grommet. |
45973 fans like us!
About Us
Site Map
Shop by Brand
Liquid Cooling
