 |
77 users browsing
|
| thisispatrick (1) |
Results: 1-1 of 1 |
 |
02-27-2010
 Alright, but needs improvement.
Some problems I encountered when I tried to install this on my HAF 932
1. Front intake section- Was hard to fit the filter in there with the fan already in place. I ended up taking the mesh off and just superglue-ing it onto the fan.
2. Side panel- The screws included were not long enough so there was no surface for me to screw the nuts on. I ended up taking the mesh off and super glue-ing that on to the fan as well.
Other thoughts- Why did they make this 2 layers instead of 1? There are 8 tiny screws you can take off, removing the mesh from the back frame. They should have just had the mesh on one frame only, that way there is no extra width to the filter.
Overall it is an ok product but the people designing this definitely need to try their products out on their "supported" cases as well. |
|
 |
3471 fans like us!
About Us
Site Map
Shop by Brand
Liquid Cooling
