 |
79 users browsing
|
| fds (1) |
Results: 1-1 of 1 |
 |
02-06-2011
 Good stuff
It comes with 4 mats, 2 big ones for the side panels and 2 long rectangles for top and bottom. I didn''t use the latter 2 because they would greatly inhibit airflow. I did however cut out a square to cover the area behind my hdd cage (hides cables nicely).
I''m using a CM690II Advanced and I was able to fit both side panel mats in. The left side panel went on with clearance for my Hyper212+. It''s thinner than I expected. I redid all my cable management and got the back panel on flush with a full sheet installed. This is impressive considering how many cables there are back there (I am using the non-modular Corsair 650TX). I cut out some black plastic squares from a binder laminate to cover the side fan holes so the sticky side wasn''t exposed to dust. Since my side vents are covered my temps were raised 3-5C overall. This case is already cold with x4 1450rpm gentle typhoons, so it''s not a big deal.
The stuff is also very easy to cut and it peels off without leaving residue. I know because I pulled it up to flatten out air bubbles. The noise and vibration difference is minor, but as an earlier reviewer stated, every decibel counts.
Lastly, the frozen cpu logo is stamped on with some silver ink that streaked a little bit in the package. It''s not engraved as I thought I saw in one of the stock pictures. You don''t get much for $20, but it''s still worth it. |
|
 |
3471 fans like us!
About Us
Site Map
Shop by Brand
Liquid Cooling
