 |
10-04-2011
 Great Fan But RPM Speeds keep decrease on Fan Controller
Notice that these fans here will not fully go up to 1650 or less you connect them to the motherboard, they work ok on fan controllers but the Alarm keeps sounded when the Fan RPM speeds decrease to 700RPM''s. Other than that they are well perform fans and they are quiet I''d have t say. |
 |
09-24-2011
 Pump caught fire and already got a third pump
So the second replacement pump caught on fire and started to smoke.. the Pump are just dying left and right and already I''m on the third one as I''d write this review. Pump are made cheap, that is what happen when you get Made in China products |
 |
09-24-2011
 O rings are very cheap and not strong enough
As what DG2 said before in this review" The o rings that came with min are nothing like what you see. They are huge and overshoot the nut. When you begin to tighten it down they squeeze out and are useless. This sets going back." will not recommended at all using this, The O right is made cheap and not strong enough with pressure is push on the o ring. |
 |
09-24-2011
 Comes in handle
Works great if you are looking for a 3 pin Y when doing push and pull on water cooled RADs. Plus they work great with fan controllers and you can control two fan on one line. |
|
07-17-2011
Replacement REV/Pump Updated
NO, I haven''t contacted frozenCPU about my issue with my REV/PUMP but I directly contacted XSPC and they ask me to make a video and send them the video of the noisy PUMP sound. The next day they ask for my address and information and send me a replacement from Hong Kong, China 2 day AIR mail to the US in Wisconsin. It was the fastest replacement service of all time from anyone ever. XSPC does get my 100% approved stamp for sure. That was the fast email response time within 24-48 hours and less than 5 days I has a new REV/PUMP. I even have a Youtube here http://www.youtube.com/watch?v=wvoTUST6uBU
If you have issues with pump then don''t even bother contacted where you made the purchase. Contact XSPC directly. |
|
06-27-2011
The Kit Is Great But Pump Started To Make Noise
Well I only had the kit for about SEVEN days before the pump started to make this bzzz noise that is now becoming a bit a headache. Other than that I would like to say the tubing is not the best tubing and note that compression fittings don''t fit 7/16 but fits 1/2 bards like a charm. It does pump about 700 to 750lph but the pump started to make that noise the LPH now when down to 645lph....and at times it does go back to 700 so I''m going to contact FrozenCPU in the morning because I just heard back from XSPC and it was said to contact FrozenCPU... I hope that I don''t get the run around because I only had this kit for seven days before it start to act up. I don''t have an extra CPU cooler anymore because I sold the H50 to someone. The thermal grease isn''t the best so please use some aftermarket thermal grease. I will make another submit review after seeing some results about this pump |
 |
06-18-2011
Excellent Coils, 5/5
Just install my XSPC Rasa water coolin g kit and these help the 7/16 tubing that comes with the kit not to KINK....using the 1/2 OD Bards gives it a very nice tight squeeze that works excellent. But the coils are very good quality.. |
3471 fans like us!
About Us
Site Map
Shop by Brand
Liquid Cooling
