 |
10-06-2011
 Great Combo
This res/pump combo is great. If the single speed model of the pump is available, buy that because you can''t really access the back of the pump when it''s in the housing to change the speed if you get the variable model. Plus, when the hydraulics kick in after 30 seconds it doesn''t matter anyway. My only issue with this res is that (as has been mentioned by another reviewer) it''s a little hard to bleed air from the loop because the tube only ends about 3/8" from the mouth of the pump so air just gets sucked back in. To be honest though this doesn''t change my opinion of this product. Bleeding air is always a hassle no matter what setup you have and as long as you''re patient and run the loop for five or six hours while rotating the rad every once in awhile, it''ll bleed just fine. |
 |
10-06-2011
Spectacular Flow
Love this pump, can''t say enough about it. I''m running a single loop with CPU, mobo and dual GPU blocks with a quad rad and almost 10 feet of tubing. This thing blasts water through all of it. Works extremely well inside the XSPC Dual Bay Res. |
 |
10-06-2011
Works Great, Doesn''t Leak
Works as expected with other Bitspower fittings. No leaks. I just tightened as hard as I could with my fingers. I''m using this in combination with two Bitspower 7/16" CFs and a Bitspower G1/4" extender with a Bitspower temp gauge plugged into it. Works great. |
 |
10-06-2011
Works as Expected
Works well to keep cables and fingers out of fans. |
 |
10-06-2011
Great Filter
Works well and doesn''t cause much slowdown. |
 |
10-06-2011
Works Well
Bought two of these and they work well. I tested the loop with straight fittings in place of these 90 degree ones and found no noticeable difference in flow or temps. |
 |
10-06-2011
LOVE these Fittings!
Can''t say enough about these fittings. I did my whole loop with nothing but these fittings and a couple of the 90 degree version of this one. I tightened mine about as hard as I could with my fingers, no leaks. They are a lot bigger than they look in the photos. There was just barely enough room to put these between my GPU''s and they have two slot length''s between them. Make sure you have enough room for them. They look spectacular though and I really can''t complain at all. |
 |
10-06-2011
Love these Fans
I have eight of these in a push/pull on my XSPC quad rad. You can hear them, but barely. I have them attached to a Scythe Kaze Q-8 which works really well. |
 |
10-06-2011
Great Extender
Works great, doesn''t leak. Tightened as hard as I could with my fingers. Looks awesome with my other Bitspower fittings. |
 |
10-06-2011
Good Idea
I put this in a T fitting with a G1/4" extender so the cylinder doesn''t stick up and impede flow. Seems to be pretty accurate. I modded my case (NZXT Tempest) by putting a hole in the top for the screen and it looks great. |
45961 fans like us!
About Us
Site Map
Shop by Brand
Liquid Cooling
