The baybus allows you to control the speed of the fans via a simple switch with three different settings. This allows fans to run at full speed (12v), half speed (7v), or off. With a baybus, you can make all the fans in your case virtually silent while you’re surfing the web or using other low demand applications. At the flip of a switch you can be back at full cooling power for gaming or other heat generating applications. This is ideal for those who want to balance cooling and noise levels with ease.

3 switch baybus that fits on a 3.5" face plate. Each switch is rated to a spec of 8W of power, which is 33% higher than the classic 6W for older baybus designs. This means that you have a fair bit more overhead for hooking up a more powerful fan/more fans.

Stats:

3 independant fan channels

Bi-Color LED on each switch (High- red, low- blue, Off- off)

8W per channel (pre-production units tested stable and safe at 14W on each channel at once, for a total power consumption of 42W across the baybus.)

Easy Access screw down terminals located on the rear of the PCB instead of the front.

4 pin molex connection also located on rear of PCB for easier access.

Pot located at top of unit (one for each switch) for adjusting the low voltage level. Adjusts from 7-9V (Higher voltages are required for fans such as sunons that won't run at 7volts)


There's the hard stats on the hardware itself, now here's what you'll get when you see one:

The baybus PCB which comes with all 3 switches and LEDs pre-installed.

A lexan drill template for the 3.5" bay cover (already has adhesive installed on the plate for mounting)

3 LED clip holders for the LED holes

Detailed instructions explaining installation and setup

1 year warranty against defects.

Review - GruntvillE.com

Part #:	bus-13
		196 In Stock, Ships Today Till 6pm EST
Note:	If an option is out of stock, click on 'Notify' next to the option to receive an email when the part is in stock.