|Phone: 1.877.2.GET.COOL (1.877.243.8266) Hours: M-F 12-5pm||55805 fans like us!|
48 users browsing
My Wish List
Who We Recommend
The Swiftech Lok-Seal™ Compression Fitting G1/4 Thread - 3/8" ID x 5/8" OD is a compression fitting used for tubing with 3/8" inner diameter and 5/8" outside diameter.
Initial Tip: If possible, attach the fittings to the cooling devices first! While not mandatory, it is always preferable to fasten a fitting to a cooling device prior to installing the device inside the case. This will eliminate interference issues that may be encountered when working with tools inside of space constrained enclosures.
Fasten the fitting by hand until it mates with the surface of the cooling device. The amount of force necessary to screw the fittings down in “finger tight” mating position may vary from one device to another depending on various factors. Users are advised to always visually check on the actual position of the fitting relative to the device surface rather than solely relying on feel. There should be little -not to exceed the thickness of a sheet of paper, or no visible gap between the fitting lower lip and the device surface. See the illustration below.
For complete long-term safety and leak-free operations, Swiftech® recommends that the fittings be locked in place using the recommended tools and that the torque levels specified below be applied:
(*) For full 5mm thread depth – please inspect the device threads prior to applying the maximum recommended torque – when partial threads exist due to application necessity, only apply the minimum torque.
Total Reviews: 1 Average Rating:
This does the job09-15-2014
Reviewer: Ned C. (13)
So I got this instead of bitspower fittings to go in the back of my corsair carbide air 540. It does the job at a much better price than the bitspower fittings.