|Phone: 1.877.2.GET.COOL (1.877.243.8266) Hours: M-F 12-5pm||55805 fans like us!|
44 users browsing
My Wish List
Who We Recommend
A 1/4 sheet of EXTREME thermal pad! This is the cream of the crop for thermal pads. With a 11.0 watt/mk thermal conductivity these pads will pull heat away from your important components! Make your own sizes to fit anything you need with this full sheet. The Fujipoly System Builder Thermal Pad starts at 150mm x 100mm (5.9" x 3.93") and is 0.5mm thick. Both sides have a protective plastic that can be peeled once ready to apply. Don't be left without when knee deep in your next build!
ModRight Brings a rigid blister pack to Fujipoly to ensure a perfect product when shipped! Genuine Fujipoly inside!
-Cut to Fit Application
-Peel Protective Film From Both Sides
(either side can be used down)
Total Reviews: 4 Average Rating:
Terrible website design05-05-2015
Reviewer: Ian (1)
The checking out experience here is just terrible. At first, after click checkout, there are no options to continue like any other online shopping to input address and payment method. I have to go back to address book and specially type in my address there then click "use". That''s not the END. When I finally filled out everything, address, mailing method, payment information, agree to their policy, again, there is NO final checkout bottom for me to place my order!! The only thing showing up there is "go back". well, then that''s it. It is supposed to be very good thermal conductive pad. But guess I can never buy it from this website.
Reviewer: bassclef (1)
I replaced the included thermal pads on my EK waterblock with these and my VRM temps dropped nearly 20C. It is a bit fragile to work with but the results are well worth the effort.
Reviewer: Bob M (1)
I purchased this in an attempt to lower the temperatures on an Areca 1882ix that was running close to 70C. OUCH! Using this Thermal Pad my temps are now topping out at around 40C. Totally Amazing!
Reviewer: Kneedle (1)
Its a bit hard to work with, but its a HUGE improvement over OEM. This is the stuff to buy when re-doing the pads on an ATI Radeon. Get this and the 1.0mm sheet, measure the thickness of the pads you''re replacing to make sure you replace them properly, and watch your temps drop!!!