A custom cut piece of Ultra thermal pad! This is the cream of the crop for thermal pads. With a 17.0 watt/mk thermal conductivity these pads will pull heat away from your important components! Both sides have a protective plastic that can be peeled once ready to apply. Don't be left without when knee deep in your next build!


Directions:
-Cut to Fit Application
-Prep Surface
-Peel Protective Film From Both Sides
-Apply Pad
(either side can be used down)

• Extreme Quality
• Above Standard Thermal Conductivity
• Easy to Use
• Easily Cut / Altered for All Applications

Thickness:	1.0^±0.1 mm
Thermal Resistance:	0.21 °Cin^2/W
Color:	Light Gray
Thermal Conductivity:	17.0watt/mk
Volume Resistivity:	1.0 x 10^5 M Ohm(m)
Withstand Voltage:	15kV/mm(AC)
Specific Gravity:	3.2gr/cm^3
Hardness:	80 Shore 00
Elongation:	35%

09-18-2014
Reviewer: mark_thaddeus (1)
I bought a pack of this pad to see if it was as good as some people have claimed it to be. My old temps for my mosfets were 60 *C to 63*C, now here are the results: Ave = 50.7*C Min = 48.1*C Max = 53.2*C This was measured using a Mastech 6520A infrared thermometer while running Heaven 4.0. The mosfets were measured by aiming at the bottom part of the heatsink closest to the mosfet. I would say pretty outstanding results! Now excuse me as I stock up on these things!

07-04-2013
Reviewer: Delitus (1)
Full load VRM temperatures for my 7970 went from ~110c to just over 40. I''m absolutely floored.