These exclusive cables are designed to operate the Vandal Switch with ring illumination.

Plug the spade connectors of this LED cable onto the outer most connectors on the Vandal switch and plug the other end onto your motherboard's HDD LED jumper.

The required resistor for the LED is built into the cable.

Length:	455mm (including connector length)

02-24-2012
Reviewer: Riffix (4)
The pictures are misleading, does not come with sleeve or heatshrink, just bare wires. Worse, the connectors on the end are much too large for the bulgin connectors. Even in the pictures here you can see that they are huge on the bulgin pins which are designed for 2.8mm connectors. These only work if you turn them in strange ways and crimp them. Save the headache and get the mod/smart 2.8mm ones.

01-31-2012
Reviewer: RPerry916 (12)
The Good- its wire and works as intended. The Bad - Ordered this wire thinking it would come in the green sleeve as it DOES NOT mention anywhere it doesnt. Its is shipped to you as just wires. A little misleading but does its job.

01-31-2012
Reviewer: RPerry916 (12)
Does not come with sleeve. just bare.