|Phone: 1.877.2.GET.COOL (1.877.243.8266) Hours: M-F 10-6||55805 fans like us!|
15 users browsing
My Wish List
Who We Recommend
The function of this device is to connect up to 8 PWM devices (fans and/or pumps) to a single PWM fan conector on the motherboard, thus enabling speed-control of all connected PWM devices concurrently.
We generally recommend to use the “CPU_Fan” connector of the motherboard,because most motherboard manufacturers usually allow a greater range of adjustments on this particular connector. PWM capable connectors must necessarily be 4-pin, but not all 4-pin motherboard connectors implement or enable the PWM signal modulation by default. Please carefully consult your motherboard documentation in this respect.
Since only one RPM signal can be read by one motherboard connector, only channel 1 of the PWM splitter carries an RPM signal; thus the motherboard will only read the RPM signal of the PWM device that is connected to channel 1 of the splitter.
The PWM signal cable has 2 wires: 1 for the PWM signal, and 1 for the RPM signal.
Power to the PWM splitter is supplied by a SATA connector that must be connected to the Power supply.
Total Reviews: 9 Average Rating:
Reviewer: Irisservice (2)
Working good with my 6 Noctua fans
Reviewer: ZmanFTW (1)
Does what it says it is supposed to do and does it perfectly. HIGHLY recommended!
Does work with corsair fans02-05-2015
Reviewer: Lostfate (1)
In response to other commenters post I have this splitter running 8 corsair fans perfectly fine. Initially I had the same issue you were reporting when on a regular fan channel. switching to the cpu header channel as the instructions say fixed this issue. all fans now have full speed control via motherboard cpu header.
Reviewer: Irisservice (2)
Does exactly what is says it does. Using on my optional CPU fan header on Asus X79 Deluxe.
Does NOT work with Corsair PWM fans.12-31-2014
Reviewer: Sociopath (1)
Look well built, rather nice splitters actually. Needed to run 4 fans for now and will be adding 2 more when I upgrade one of my radiators to 480mm. The mounting tape on the back is too thin to really mount to anything, I had to remove it and use my own thicker 3M mounting tape. After getting this mounted and all wires ran my fans would only run at 100%. I have been running Speedfan for months on this system running my CPU rad and case fans with out issue. After doing some research on Swiftechs help forums this is a known issue with Corsair PWM fans and this unit. Apparently Corsair fans need a very strong PWM signal to function. Since this has no kind of signal booster built in it will not allow PWM control of (in my case more than 3 fans) more than 4 fans at one time. Not Swiftechs fault, but would have been really nice to know before spending the money and all the time getting these wired into my build.