Est. 1999
Phone: 1.877.2.GET.COOL (1.877.243.8266)   Hours: M-F 12-5pm 55805 fans like us! Bookmark and Share


41 users browsing
Become a Fan on Facebook Follow FrozenCPU on Twitter Subscribe to our RSS Feed






Mystri (8) Results: 1-8 of 8
01-29-2011
4 out of 5
Nice quality, but it''s slightly translucent allowing the wire color to hint through; looks kinda cool if that''s the look you are going for. However, if you want full coverage on your PSU wires (16-18 gauge) go with the 1/4" and pull it tight with a very slight twist. This does give full color coverage on your smaller gauge wires (fan, Power/Reset, HDD LED, Power LED, etc/ *mine are 22-26 gauge) just heat shrink one end and pull it tight with a very slight twist.
01-29-2011
Beautiful!
Excellent quality with great coverage of your wire color. Has a slight sheen that looks wonderful with case lighting. This size is perfect for PSU wires (mine are 16-80 gauge) can work on smaller fan wires (mine are 26 gauge) if you tighten it up with a slight twist. Expands to about 1/4" to get over connectors and double wires (PCI-E 6+2 for example) but not much more than that and you''ll see the wire color through it (if you need to do double wires go with the 1/4") Just touch the cut ends with a lighter to prevent fraying and you will be good to go.
01-29-2011
Perfect!
Decent wall thickness (ie doesn''t shred over every connector like some of the others) Has about a 2:1 shrink on it.
01-29-2011
Perfect!
Has a nice wall thickness (ie doesn''t shred over the connectors like some of the other stuff does) Solid coverage with no bleed through even after heat shrinking. The only thing I would note is not to touch it until it''s full cooled down. I tried to fit it a bit better while it was warm and it got a pinkish flash of color in it where I touched. Shrinks about 2:1
01-29-2011
Great product
Love the concept and they work like a charm, but I wasn''t too happy with the silver color. It won''t match your brushed aluminum or stainless steel and definitely not your chrome. It''s more of a plastic-like silver, the best way I can think of to describe it is shiny or sparkly gray. *It''s tricky to get it to work with the included adhesive magnet, you have to keep rotating one piece until you align the two magnets.
01-29-2011
Perfect
I love this thing, SSD''s and I don''t have to get rid of my old 3.5" nor give up a drive bay. :) The "external" front panel comes off with a couple screws so you can mount it internally. Your 3.5" goes in as you would expect and your SSD''s mount above that on the inside of the metal frame and are protected. Really the only bad thing I can say is fitting one of those HDD noise isolation strips on the 3.5" drive is near impossible because it''s a very tight fit...